This 2016 Audi A6 C7 3.0 TDI with front-wheel drive and an automatic transmission was tested on a dyno. The video quotes factory output of 218 hp and 400 Nm, although engine variants from this period had different ratings. Software changes involving the DPF, EGR and AdBlue systems had been made earlier; this visit focused on completing the engine power calibration.

Dyno results

One post-calibration run produced approximately 283 hp and 510 Nm. Repeat runs showed about 278–280 hp and 514–515 Nm. These are readings from separate runs, not a single identical measurement.

The owner came in to complete the calibration and measure the result on a suitable dyno. The video also shows a road check after the work.