This 2007 Audi A6 C6 3.0 TDI with an automatic transmission was dyno-tested and calibrated for everyday driving. The initial run with the software already in the vehicle recorded 227 hp and approximately 430 Nm. The factory power figure quoted in the video is 233 hp.

After a Stage 1 ECU calibration, the dyno recorded about 260 hp and 530 Nm. A repeat run produced around 260 hp and 535 Nm. Compared with the initial dyno measurement, that is an increase of approximately 33 hp and 100–105 Nm.

The test configuration had the DPF removed while retaining the catalytic converter. The video reports that the original DPF had been heavily clogged. No pronounced black smoke was observed during the final dyno run; long-term exhaust-system operation was not described.