The factory output of this 2014 Audi A6 C7 3.0 TDI is 204 hp and 400 Nm. The owner wanted stronger pulling power rather than the highest possible peak output. Before making changes, the engine and transmission control software was reviewed; the video notes that torque settings in the transmission limited the available margin in some operating ranges.

Both the engine ECU and transmission control were calibrated. After the work, dyno readings were approximately 241–242 hp and 573–574 Nm. Repeat runs produced similar figures. The vehicle’s emissions equipment was retained because the owner planned to use the car in Europe.

A further power increase was discussed but not carried out. The owner chose to keep the selected setup and gain more torque for everyday driving. The figures reported here are from the specific dyno measurements.