Vehicle condition and baseline measurement

The workshop checked a 2013 Volvo XC60 D4 with an automatic transmission and all-wheel drive. The odometer shown in the video read 216,696 km, and the emissions-control systems remained in place. The factory nominal figures mentioned in the video are 163 hp and 340 Nm, while the initial dyno run recorded approximately 146–147 hp and 380 Nm.

Stage 1 calibration

After the baseline run, Stage 1 software was prepared for the engine control unit. The vehicle was then tested again on a synchronised all-wheel-drive dyno.

Dyno result

After calibration, the dyno showed 227 hp and 460 Nm. Compared with the initial dyno measurement, the increase was approximately 80 hp and 80 Nm. The +120 Nm figure in the video title comes from comparing the result with the factory nominal torque of 340 Nm, rather than the initial dyno reading of 380 Nm.